Saturday, July 9, 2011

Rolex watches head table of icons and their meanings

As long as the head of brand name watches on the table there will be icons, this and cars, watch the LOGO is absolutely necessary to mark out side in a conspicuous place, LOGO are generally graphics, there are letters, such as full name with the watch or prefix or abbreviation. Head table icon can be considered a beautiful watch, "landscape", representing the original original, Seiko secret agents; fake pseudo-table in the nuances tend to do well, fuzzy rough is a common problem.
    Oyster case with a Rolex watch, excellent waterproof performance, this is also the structure of its watch list, because the table to watch alone is moving parts, it needs to be operated frequently, so the seal is particularly important this place . Rolex watches are used in the structure of the screw lock buckle and tighten the seal will be like after the cork; and where at least two instances of the sealing gasket; green water like a ghost (16610LV model) and the Daytona series type watches, waterproof up to 3 re-sealing rubber ring, that an increase in the watch case of the handle of the first outer tube, pull out the table can see.
    Rolex watches at the head table, there would be identified, in the Rolex crown logo below GOLO, said with a dot or dash, a dot there, there are two, there are three of these identification represents the watch case material, but also represents the start of the case and the structure.
Identification of the specific meaning
    1, a representative dot is PT950 platinum watch case, a significant proportion of the precious metals, watches weigh up more pressure hand;
    2, two representatives of the origin of the watch with 18K white gold or gold case;
    3, the origin of the trouble these three, the first head of the table it has more than 6 mm in diameter, should be 7 mm, this table is usually used for the case diameter of 40 mm or more watches, Rolex watches, the standard male section about 36 mm case diameter, with a table with the head diameter is 6 mm, then a small number of watches, table head diameter may be 5.3 mm.
    4, a dash up the case, the dash is like a "wild card", on behalf of the watch is waterproof case is twofold, the table is made of 18K gold, 18K gold and stainless steel, or pure stainless steel, in Rolex watches, this configuration is the most common.

    Three origin can also understand it as triple waterproof, with this type of table to watch, the handle can be seen outside of the first pipe sealing gasket. In water, based on the triple, if the watch case material the use of platinum, its origin in the middle of three which will be relatively small; if the watch case material the use of 18K white gold, then the three sides of the origin will be relatively small .

    When the three origin generally large, the situation is equivalent to using dashes, usually made of 18K gold case, 18K gold and stainless steel or pure stainless steel.
    Early Rolex watch list to identify the range of the head, even with a cross and English, in the past 30 years to identify a relatively fixed, the basic is the above mentioned those circumstances, does not meet the rules, many are likely to be off the table , Rolex watches on the table to double and triple water structure, next look for opportunities to do a special introduction.

No comments:

Post a Comment